Tired of your suction cup 1X and 2X dash lights falling down? We have the solution for you! Our custom dash light adapters are now available to purchase! These are sold in pairs. One pair does one dash light. Dash light not included. The installation instructions are as follows:

Simply remove the suctions cups for your dash light and bolt up the adapter using the supplied hardware. Don't not over tighten screws. Do not use an electric screw driver or drill. Once that is complete place light on windshield and using masking tape make the outside of the glass exactly where the dash adapters are going to be placed. Once you have it marked, clean the inside of the windshield very thoroughly with 70% rubbing alcohol. Once it is clean use the supplied 3M adhesive promoter and coat the glass where the tape is marked. Make sure you do not touch the surface with your hands after this is done. Remove the red backing from 3M VHB tape and carefully place on windshield where you marked it. Once it is stuck it can not be remove or relocated. If the surfaces are not properly prepped the 3M will not hold up. If it falls you will have to remove and replace the 3M VHB tape and redo the process. The 3m VHB comes pre-applied to the adapter.